Key Functions - BLADEZ T1 Basic Owner's Manual

GETTING STARTED CONTINUED
SAFETY KEY & CLIP
Your Bladez treadmill is equipped with a safety key that will disable the
treadmill if it is not in place. You should attach the clip end to your clothing.
The magnet end goes into the recess in the center of the console. If at any
time you need to stop the treadmill simply pull the safety key quickly off the
console. This will cut all power to the treadmill and it will come to a
complete stop. To restart the treadmill, place the safety key back in place.
You will then need to program your workout again.
BEFORE STARTING
Straddle the walking belt and stand on the side rails. Insert the safety key
and attach the clip to your clothing. Do not stand on the walking belt while
starting or stopping the treadmill.

KEY FUNCTIONS

START – This key is used to begin any treadmill program or quick start.
MODE – This key is used to enter into the program mode. It is also used to
change the values on the display between incline and pulse.
STOP – This key is used to stop the treadmill at any time. Pressing and
holding the STOP button 3 seconds will reset the treadmill.
ENTER – This key is used to confirm your selection.
These keys are used to adjust the speed of the treadmill.
These keys are used to change values during programming.
They are also used to adjust the elevation of the treadmill.
INSTANT SPEED KEYS – You can change the speed of the treadmill by
pressing one of the Instant Key buttons. The keys represent Miles per Hour
(MPH).
BladeZ Corporation • 20155 Ellipse • Foothill Ranch • CA • 92610
www.ebladez.com
9
• Phone 949-206-8152 • Fax 949-206-0013