Billion BiPAC 7800NL User Manual page 76

DHCP Server
You can disable or enable the DHCP (Dynamic Host Configuration Protocol) server or enable the
router's DHCP relay functions. The DHCP protocol allows your router to dynamically assign IP
addresses to PCs on your network if they are configured to obtain IP addresses automatically.
Disable
Disable the DHCP Server function.
Enable
Enable the DHCP function, enter the information wanted. Here as default.
Start IP Address: the start IP address of the range the DHCP Server used to assign to the Clients.
End IP Address: the end IP address f the range the DHCP Server used to assign to the Clients.
Leased Time: the leased time for each DHCP Client.
Maximum Leased Time(hour): the Maximum Leased Time(hour).
DHCP Server Relay
If you check DHCP Relay and then you must enter the IP address of the DHCP server which
assigns an IP address back to the DHCP client in the LAN. Use this function only if advised to do so
by your network administrator or ISP.
73