Introduction - Kenwood AP-300-B Instruction Manual

Introduction

Auto Power Save function (APS)
The System comes with an "Auto
0
Power Save (APS)" function, which
turns off the power automatically
when no sound is output for 15
minutes. This function is enabled in
the default setting. (page 15)
In this manual...
The remote control buttons are used for
0
explaining the operations unless mentioned
otherwise. Button unless mentioned otherwise
indicates the remote control buttons.
However, if the System has buttons with the
same or similar names, they can also be used
for the operations.
The display shown in this manual may differ
0
from the actual display in some cases.
In this manual...
In this manual, "iPod" includes iPod, iPod
0
touch and iPhone devices. When referring
specifically to iPod touch or iPhone, "iPod
touch" or "iPhone" is used respectively.
In this manual, the term "Android device" is
0
referred to as a smartphone and a tablet
device, that are equipped with the Android OS.
In this manual, "file" and "track", "folder" and
0
"group" are used interchangeably.
Declaration of Conformity with regard to the
EMC Directive 2004/108/EC
Declaration of Conformity with regard to the
R&TTE Directive 1999/5/EC
Manufacturer:
JVC KENWOOD Corporation
3-12, Moriya-cho, Kanagawa-ku, Yokohama-shi,
Kanagawa 221-0022, Japan
EU Representative's:
Kenwood Electronics Europe BV
Amsterdamseweg 37, 1422 AC UITHOORN, The
. Netherlands
.
Hereby, Kenwood declares that this unit
AP-300-B/AP-300-H is in compliance with the
essential requirements and other relevant
provisions of Directive 1999/5/EC.
Ways to press the buttons
There are two ways of pressing the buttons on
the System. "Short press" refers to the action of
pressing a button and releasing it immediately,
while "long press" refers to pressing and holding
down a button.
Short press: Applicable to cases where "long
press" is not indicated
Press a button lightly and release it instantly. The
System may not respond if excessive force is
applied to a button or if the button is not released
instantly. If it does not respond as intended, retry
by adjusting how long a button is pressed or the
amount of force applied.
.
Long press: Applicable to cases where "long
press" is indicated
Press and hold down
.
Press and hold down a button, followed by
releasing the finger.
IMPORTANT FOR LASER PRODUCTS
1. CLASS 1 LASER PRODUCT
2. CAUTION: Do not open the top cover or
cabinet. There are no user serviceable parts
inside the unit; leave all servicing to qualified
service personnel.
The product label of this product or the other
information are located at the bottom of the
System.
Release quickly
3