Assembly - Craftsman 919.165520 Owner's Manual

Contents of Carton
1 - Air Compressor
1 - Handle
1 - Grip Handle
1 - Hose Wrap
2 - Self Tapping Screw 1/4-20 x 1.25
2 - Wheels
2 - Shoulder Bolts, 3/8-16
2 - Hex Nuts, 3/8-16
1 - Rubber Strip
Tools Required for Assembly
1 - 9/16" socket or open end wrench
1 - 1/2" socket or open end wrench
1 - 3/8" socket or standard
screwdriver
Unpacking
1. Remove unit from carton and
discard all packaging. NOTE:
Save all parts bags.
Assemble Handle and Hose Wrap
1. To make installation easier,
submerge handle grip into warm
soapy water. Remove handle
grip from soapy water and slide
onto handle.
2. Insert the handle inside the
compressor saddle.
3. Line up the two bolt holes in
saddle with handle and hose
wrap as shown.
4. Install the longer self tapping
screws, supplied with the hose
wrap through hose wrap, saddle,
and handle.
5. Install the shorter self tapping
screws through the saddle and
handle on the other side.
6. Tighten all screws securely. Be
sure not to over-tighten.
handle to push, pull, or lift air
compressor.
D27221

ASSEMBLY

DO NOT use
hose wrap as a
Hose
Wrap
Screws
(long)
Shoulder
Wheel
Bolt
provide adequate clearance,
stability or support for pulling the
unit up and down stairs or steps.
The unit must be lifted, or pushed
up a ramp.
Assemble Wheels
brace or support one side of the
outfit when installing the wheels
because the compressor will have
a tendency to tip.
1. Attach wheels with shoulder
bolts and nuts as shown. NOTE:
Place the bolts in the bottom
hole of the wheel bracket on
units 20-29 gallons and in the
top hole on units 30 gallons and
up.
2. Tighten securely. NOTE: The
outfit will sit level if the wheels
are properly installed.
Assemble Rubber Feet
1. Attach rubber
feet with the
screws,
washers and
nuts provided
as shown.
2. Tighten
securely.
10- ENG
Screws
(short)
Handle Handle Grip
Nut
Washer
Nut
Rubber Foot
Screws
The wheels and
handle do not
It will be
necessary to
Rubber
Foot
Screw
Nut
Flat
Washer