Assembly - Craftsman 919.724500 Owner's Manual

Contents of Carton
1 - Air Compressor
1 - Handle
1 - Grip Handle
1 - Hose Wrap
2 - Self Tapping Screw 1/4-20 x 1.25
2 - Wheels
2 - Shoulder Bolts, 3/8-16 x 3.40
2 - Hex Nuts, 3/8-16
2 - Rubber Feet
2 - Washers
2 - Screws
2 - Nuts
Tools Required for Assembly
1 - 9/16" socket or open end wrench
1 - 1/2" socket or open end wrench
1 - 3/8" Socket or standard
screwdriver
Unpacking
1. Remove unit from carton and
discard all packaging. NOTE:
Save all parts bags.
Assemble Handle and Hose Wrap
1. To make installation easier,
submerge handle grip into warm
soapy water. Remove handle
grip from soapy water and slide
onto handle.
2. Insert the handle inside the
compressor saddle.
3. Line up the two bolt holes in
saddle with handle and hose
wrap as shown.
4. Install the longer self tapping
screws, supplied with the hose
wrap through hose wrap, saddle,
and handle.
5. Install the shorter self tapping
screws through the saddle and
handle on the other side.
6. Tighten all screws securely. Be
sure not to over-tighten.
to push, pull, or lift air compressor.
D26706

ASSEMBLY

DO NOT use hose
wrap as a handle
Hose
Wrap
Screws
(long)
Shoulder
Wheel
Bolt
provide adequate clearance,
stability or support for pulling the
unit up and down stairs or steps.
The unit must be lifted, or pushed
up a ramp.
Assemble Wheels
one side of the unit when installing
the wheels because the compressor
will have a tendency to tip.
1. Attach wheels with shoulder
bolts and nuts as shown.
2. Tighten securely. NOTE: The unit
will sit level if the wheels are
properly installed.
Assemble Rubber Feet
1. Attach rubber
feet with the
screws,
washers and
nuts provided
as shown.
2. Tighten
securely.
10- ENG
Screws
(short)
Handle Handle Grip
Nut
Washer
Nut
Rubber Feet
Screws
The wheels and
handle do not
It will be necessary
to brace or support
Rubber
Foot
Screw
Nut
Flat
Washer