Assembly - Craftsman 919.165511 Owner's Manual

Contents of Carton
1 - Air Compressor
2 - Wheels
1 - Hose Wrap
2 - Self Tapping Screws,
1/4-20 x 1.25
2 - Shoulder Bolts, 3/8-16 x 3.40
2 - Hex Nuts, 3/8-16
2 - Rubber Bumpers
2 - Screws, 1/4-20 x .75
Tools Required for Assembly
1 - 9/16" socket or open end wrench
1 - 1/2" socket or open end wrench
1 - 3/8" socket or standard
screwdriver
Unpacking
1. Remove all packaging leaving
the air compressor on the pallet.
2. Remove and discard the (4)
screws holding the air
compressor to the pallet.
Screws
or support one side of the air
compressor when removing the
pallet because the air compressor
will have a tendency to tip.
3. Carefully remove the air
compressor from the pallet.
Assemble Hose Wrap
1. Line up two bolt holes in saddle
with holes in hose wrap as
shown.
2. Install the self tapping screws
through hose wrap and saddle.
3. Tighten securely. Be sure not to
over-tighten.
D27302

ASSEMBLY

It may be
necessary to brace
push, pull, or lift air compressor.
Assemble Wheels
Nut
one side of the air compressor
when installing the wheels because
the compressor will have a
tendency to tip.
1. Attach wheels with shoulder
bolts and nuts as shown.
2. Tighten securely. NOTE: The air
compressor will sit level if the
wheels are properly installed.
provide adequate clearance,
stability or support for pulling the
unit up and down stairs or steps.
The unit must be lifted, or pushed
up a ramp.
Assemble Rubber Feet
1. Attach rubber feet with the
screws provided as shown in
previous figure.
2. Tighten securely.
10- ENG
Hose
Wrap
Self
Tapping
Screws
DO NOT use hose
wrap as a handle to
Rubber
Feet
Screw
Wheel
Shoulder Bolt
It will be necessary
to brace or support
The wheels and
handle do not