Heat & Glo SL-750TRSFHHIPI Owner's Manual page 62

NOTCH
STEP 4.
LOG #3 (SRV2066-703) Place log #3 on right side of
grate. The notch on the log should fi t over the bar on the
far right side of the grate. Push the right side of log #3
against the grate tab and pull the left side forward until
it comes into contact with the burner detail as shown in
Figure 1.
STEP 5.
LOG #4 (SRV2066-704) Place log #4 so that the notch
is touching the fi rst grate tine and is laying in the fl at spot
of log #2. The right end of log #4 should touch the back
refractory panel. See Figure 14.7.
STEP 6.
LOG #5 (SRV2065-705) Place log #5 on log #2. Log #5
will mate with the grooves located on the top side of Log
#4. See Figure 14.8.
62
Heat & Glo • SL-750TRSFHHIPI • 2156-900 Rev. F • 11/08
1 1
LOG/BURNER DETAIL CONTACT AREA
Figure 1.
LOG TOUCHES REFRACTORY PANEL
4 4
1 1
NOTCH
Figure 14.7
MATE WITH GROOVES HERE
4 4
1 1
Figure 14.8
2 2
3 3
2 2
3 3
5 5
2 2
3 3