Sundance Spas 880 Series Owner's Manual page 19

7. Select the power supply entrance you want to use (Figures A-B,
pages 13-14) and remove the short cabinet panel from the front
of the hot tub, then feed cable through the large opening provided on
the bottom of the control box.
8. Connect wires, color to color, on terminal blocks TB1 and TB3
(Figure D). TIGHTEN SECURELY! All wires must be hooked up
securely or damage could result.
9. Install control box door and reinstall the cabinet side panels.
Figure A (Maxxus/Aspen Equipment Area)
2
9
Note: Equipment location (such as pumps, CLEARRAY® sys-
tem, drain, heater etc.) varies by model.
1. Control Box
2. Power Supply Entrance(s)
3. Jets Pump
4. Jets Pump
5. Jets Pump
6. Blower
7. Heater
8. Hot Tub Drain (Removable
External Drain Cap)
12
11
3
4
14
13
SPA CONTROLLER
7
1
10
9. Pump Drain Plug(s)
10. Filter/Circulation Pump
11. CLEARRAY® (Ultraviolet) Water
Purification System
12. Electronic Ballast (for the
CLEARRAY System)
13. Control Panel
14. Quick Drain
880 SERIES
6
5
9
2
8
Page 13