Using Dhcp - Canon imagePROGRAF iPF6400S Series Setup Manual

When the printer cannot be found on the network
If your printer cannot be found when connecting to
the network for the first time, setup an IP address
for the printer and then configure it on the printer.
When ink fills the system for the first time, after
printhead adjustment is finished, specify the IP
address on the printer's control panel.
• When ink fills the system for the first
time, do not operate the printer until
printhead adjustment is finished.
4
Enter the IP address. Navigate through
the following menus using the ▲ and ▼
keys on the control panel.
1. Select IPv4 and press OK.
2. Select IPv4 Settings and press OK.
3. Select IP Address and press OK.
4. Enter the IP address.
7
In the Search Results window, select
Specify the IP address of available
printers in the network and click Next.
When the IP Address Specifications
window appears, follow the instructions of
"When entering the printer's IP address
manually" in step 8 to 11 on page 8 to
complete the installation of the software.

Using DHCP

To use the DHCP server function to automatically
allocate an IP address to the printer, one of the
following settings needs to be configured. Check
with your network administrator for the settings
that match your system.
• Configure the DNS dynamic update function
• Configure the DHCP server to always allocated
the same IP address when the printer starts
5
For IPv4
Select On using the ▲ and ▼ keys and
then press OK.
1
On the tab selection screen of the control
panel, press the and
(settings/adj. tab) and press OK.
No Paper Loaded
OK:Setting/Adj. Menu
Maint.C Remain.: 80%
Tot.Print Area(m2):
How to enter IP addresses
1. Press the and keys to select a
MEMO
field for inputting values.
2. Use the ▲ and ▼ keys to input values.
• Pressing ▲ increases the value by
one.
• Pressing ▼ decreases the value by
one.
• Holding down either the ▲ or ▼ keys
continually increases or decreases
the value.
3. Press OK once you have finished.
• If the following screen appears, click
Retry and select Specify the IP
MEMO
address of available printers in
the network on the next screen that
appears.
This section describes how to turn on DNS
dynamic update from the control panel of the
printer.
• The DNS dynamic update function can
also be configured using Remote UI.
MEMO
Refer to "Configuring the Printer's TCP/
IP Network Settings With RemoteUI" in
the user guide for details.
For IPv6
1. When Use the same host name and
domain name as IPv4? is displayed,
select Off using the ▲ and ▼ keys and
then press OK.
2. Select Statefull Addr using the ▲ and
▼ keys and then press OK, and then
select On using the ▲ and ▼ keys and
then press OK.
3. Set Stateless Addr to On using the
same procedure as in Step 2.
9
2
Use the ▲ and ▼ keys to select Interface
keys to select Setup and press OK.
3
Use the ▲ and ▼ keys to select TCP/IP
and press OK.
678
5
Press Menu.
6
Press OK on the registration confirmation
message that appears.
The IP address is set on the printer.
Next, restart installation of the printer
driver.
1
Perform steps 1 to 3 of the procedure in
"When the printer cannot be found on the
network" on page 9.
2
Select IPv4 or IPv6 using the ▲ and ▼
keys and then press OK.
3
Select DNS Settings using the ▲ and ▼
keys and then press OK.
4
Select DNS Dync update using the ▲
and ▼ keys and then press OK.