Radio Shack 15-310 User Manual page 6

The red LED lights and stays lit, indicating that the
remote is in setup mode. Release both buttons.
n
Note: Do not hold down the keys for longer
than three seconds or the remote enters auto search
mode.
4. Enter the first 3-digit code for your device and brand.
Pause briefly between each digit to make sure the
remote receives all inputs. The red LED flashes
when input is received, then turns off if you entered
the right code. If the red LED stays lit, enter the
next code for your device and brand. Repeat for all
possible codes until the red LED turns off.
5. Verify the setup by testing the remote control's
buttons and functions. If some of your device's
functions do not respond to the remote, repeat steps
3-5 with another code.
n
Notes:
• If you want to quit during device setup, press the
device key or wait 10 seconds for the remote to exit
setup automatically.
• If you are uncertain about your 3-digit code entry,
follow "Check Current Brand Code" on page 9 to confirm
your code.
• If you've tried all the codes for your device in the
Code List and your universal remote still does not
work, follow steps for Auto Code Search or Manual Code
Search.
6