Roland V-Accordion FR-7X Owner's Manual page 60

FR-7x V-Accordion
® Charging the battery pack
Recharging the battery pack on the FBC-7
The battery pack installed in the FR-7x's compartment
can also be removed and recharged on the FBC-7 itself.
That is more tedious, though, and does not speed up the
recharging procedure.
The main use for the method described below is there-
fore to recharge a spare battery pack (which is optional)
while using the battery pack inside the FR-7x.
Warning: Before removing the battery pack, be
sure to power off the FR-7x (the blue indicator
must be dark).
(1) Switch off the FR-7x.
(2) Prepare a coin.
(3) Remove the cushion located between the Treble
keyboard and the bellows.
(4) Use the coin to loosen the two screws of the bat-
tery compartment cover.
(5) Remove the cover from the FR-7x's battery com-
partment.
Note: While the compartment cover is open, the FR-7x
cannot be switched on.
(6) Pull the battery strip so that the battery pack pro-
trudes a little from the battery case.
60
(7) Remove the connector and take the battery pack
out of the battery case.
The battery pack is connected to the FR-7x by means
of a cable. You need to disconnect the cable from the
battery pack by pressing the clip on the connector
before fully removing the battery pack.
(8) Open the FBC-7's EXTERNAL BATTERY CHARGER
compartment by sliding the cover to the right.
That portion on the FBC-7 now looks as follows (note
the connector):
(9) Connect the battery pack's cable to the charger's
socket.
(10) Slide the battery pack into the holder on the
FBC-7.
(11) Connect the FBC-7 to a suitable wall outlet.
(12) Switch on the FBC-7 by pressing its [POWER¥ON]
button (its red POWER ON indicator lights).
battery pack