Roland V-Accordion FR-7X Owner's Manual page 102

FR-7x V-Accordion
® 11. Utility parameters (Advanced)
If you selected "Reed ALL" or "Vol ALL", the following
warning may be displayed:
This only occurs if the "VALUE" next to it is currently
"---", which means that the reeds of your Set use dif-
ferent settings. By proceeding with "ALL", you would
assign the same value to all registers of the current
Set.
(a) Press the [DATA÷ENTER] knob to set the same value
for all reeds.
(b) Press the [EXIT÷JUMP] button to stop the operation
(3) Press the [DATA÷ENTER] knob to select "VALUE",
then rotate the [DATA÷ENTER] knob to select the
desired setting.
The possibilities depend on the choice you made in
step (2) above.
Parameter Setting range
Reed Bandoneon, I-Folk, I-Folk2, Classic, Cajun,
Jazz, F-Folk, D-Folk, Organetto, F-Folk2,
Classic2, Studio, Tradition, Steierische,
Trikitixa, F-Jazz, Classic3, Bajan
Vol Off, –40~Std~+40
Bandoneon, I-Folk, I-Folk2, Classic, Cajun,
Jazz, F-Folk, D-Folk, Organetto, F-Folk2,
Noise
Classic2, Studio, Tradition, Steierische,
Trikitixa, F-Jazz, Classic3, Bajan
Noise Vol Off, –40~Std~+40
Bandoneon, I-Folk, I-Folk2, Classic, Cajun,
Jazz, F-Folk, D-Folk, Organetto, F-Folk2,
Reed Growl
Classic2, Studio, Tradition, Steierische,
Trikitixa, F-Jazz, Classic3, Bajan
Growl Vol Off, –40~Std~+40
Note: Reeds that are currently off (see "4.2 Register" on
p. 74) adopt the new setting but are not switched on by
this operation.
(4) Press [EXIT÷JUMP] twice to return to the main page
and try out all 7 Free Bass registers.
(5) If you like your new settings, save them (see
p. 103).
102
11.13 Factory Reset
You can reset the FR-7x to its
factory settings, which means
that all settings are replaced
by the settings the FR-7x con-
tained when you first got it.
You may wish to archive your settings to a USB storage
device before initializing the FR-7x (see "11.4 Export All
FR-7x" on p. 98).
(1) Press the [DATA÷ENTER] knob and rotate it to select
"ALL FR-7x" or "SET:1"~"SET: 80".
Select "ALL FR-7x" to replace all settings. Select "SET:
xx" to load the factory settings only for the selected
Set.
(2) Press the [MENU÷WRITE] button.
The following message appears:
(3) Press [MENU÷WRITE] to start initializing the FR-7x.
The display briefly shows the message "Executing...
Do not power off", then "Function complete".