Remotely Linking Two Connected R-44 Units - Roland R-44 Owner's Manual

Remotely Linking Two Connected R-44 Units

You can prepare two R-44 units and connect them with control sync to record with up to 8 channels.
CTRL SYNC
● Connections
Connect both R-44 units via the Control sync connector. A stereo mini cable is required to connect R-44
units via the R-44's Control sync connector. Please purchase separately.
● System settings
Transmission Side Setup
1.
Press the [MENU] button.
2.
In 5 System Setup, set Sync Mode to Master.
* For more about system settings, refer to "System Setup" (p. 60).
Receiving Side Setup
1.
Press the [MENU] button.
2.
In 5 System Setup, set Sync Mode to Slave.
* For more about system settings, refer to "System Setup" (p. 60).
This completes the settings for remote linking.
● Recording
Press the [REC] button on the transmitting R-44 to start the recording.
Refer to "Recording" (p. 29) for information about recording settings.
Recording standby can also be linked remotely.
Refer to "Recording standby" (p. 31) for information about recording standby.
* When using remotely linked recording, be sure that Rec Freq. in Recording Setup is the same for both R-44 units.
* Remote linking does not guarantee the exact same REC start time.
* The receiving R-44 cannot record from digital input.
Transmission Side
Receiving Side
CTRL SYNC
Appendix
73