Preparing The Sd Memory Card - Roland R-44 Owner's Manual

Getting Ready to Use the R-44

Preparing the SD Memory Card

The R-44 uses an SD memory card.
The SD memory card is sold separately. Visit the Roland website (http://www.roland.com) before making
a purchase. The website provides the most recent information regarding compatibility.
Inserting the SD Memory Card
1
Confirm that the power is turned off.
If the power is on, turn it off. Press and hold the [POWER] switch on the R-44 to turn power on or off.
2
Open the Rubber flap on the side
of the unit.
3
Insert the memory card.
931
* When inserting the SD memory card, make
sure the front of the card is facing up and
insert the card slowly. If the card is forcibly
inserted incorrectly, the R-44 or the SD
memory card may be damaged. Please
exercise caution.
* Carefully insert the memory card all the way in until it is firmly in place.
4
Close the Rubber flap.
5
Turn power on.
Press and hold down the [POWER] switch to turn on the power.
When using an SD memory card with the R-44 for the first time
When using an SD memory card with the R-44 for the first time, the memory card must be formatted.
Please format the memory card following the procedure in "Formatting and Checking the SD Memory
Card" (p. 64). "SD Unformatted" is shown when an unformatted memory card is inserted into the R-44.
The SD memory card write protect feature (LOCK)
The contents of the memory card can be protected by sliding the write protect switch
on the side of the memory card to the "LOCK" position. Unlock the write protect
switch to delete data on the card.
Removing the SD Memory Card
1
Turn off power to the R-44.
2
Open the Rubber flap.
3
Lightly push the memory card inward, then release it.
Remove the memory card after it pops out toward you.
* Never insert or remove a memory card while this unit's power is on. Doing so may corrupt the data on the memory card.
28
Rubber flap
SD memory card
Write protect switch