Copying A Project (Copy) - Roland R-44 Owner's Manual

Manipulating a Project (Finder)

Copying a Project (Copy)

fig.finder-1.eps
1
Press the [ENTER/FINDER] button while the Main
screen is shown in the display. The Finder screen shown in
the figure is displayed.
Projects are shown in descending alphabetical order.
fig.finder-select.eps
2
In the Finder screen, use the Cursor buttons [
or the [SCRUB/VALUE] dial to select the copy-source
project (the project you want to copy). Then press the
[ENTER] button.
When a folder is selected, you can press the Cursor button [
folder (i.e., move to a lower-level folder).
If you want to move back to the upper-level folder, press the Cursor button [
fig.finder-copy1.eps
3
When the screen shown in the figure is displayed, use the
Cursor buttons [
the [ENTER] button.
fig.finder-copy2.eps
4
Use the Cursor buttons [
VALUE] dial to select the copy-destination folder (the
folder where you want to copy the project). Then press the
[ENTER] button to execute the Copy operation. You can
select folders or the root folder (SD) as the copy
destination.
* If you decide to cancel without copying, press the [EXIT] button.
fig.finder-copy3.eps
Do not turn off the power while a project is being copied.
* If the copy destination contains an identically named project, a number
such as -1 or -2 is appended to the name of the copied project.
50
] [ ] to select
. Then press
3 Copy
] [ ] or the [SCRUB/
] [ ]
] to move into the selected
Root Folder
].