Fujitsu PRIMERGY S60 Manual page 56

The FFx-RAID Controller Module
Description of the LED indicators
LED
7
CACHE DAC
(yellow) STATUS
(green)
OFF ON
OFF flashing
0.5 sec.
OFF flashing
1 sec.
OFF OFF
OFF OFF
OFF OFF
ON OFF
flashing OFF
0.5 sec.
flashing flashing
0.5 sec. 0.5 sec.
Table 8: FFx-RAID Controller Module: Status Indicators
48
8 9
DAC
POWER
ALARM
(red)
OFF Normal operation, module ready and partner
OK
I
OFF Normal operation, FFx-RAID controller
module not ready and partner OK.
OFF Normal operation, FFx-RAID controller
module ready and partner failed
I
ON Alarm:
FFx-RAID controller not powered (5 VDC;
3.3 VDC)
flashing Alarm:
0.5 sec. FFx-RAID controller 5 VDC failed
flashing Alarm:
1 sec. FFx-RAID controller 3,3 VDC failed
OFF Cache dirty:
Data in cache and on the hard disk drives
are not identical (cache active)
OFF Conservative Cache activated (DIP switch
K1 see "DIP Switches" on page 51)
flashing Diagnosis Mode activated (DIP switch J1
0.5 sec. see "DIP Switches" on page 51)
Plug-in Board Modules
Description
This signal is activated only if two
FFx-RAID controller modules are
used; only the non-defective module
can indicate that the other one has
failed.
This signal is activated only if two
FFx-RAID controller modules are
used; only the non-defective module
can indicate that the other one has
failed.
U41221-J-Z156-1-74