Lldp Med-Tlv-Select - TP-Link TL-SG2216 Reference Manual
Gigabit smart switch
Hide thumbs
Also See for TL-SG2216:
- User manual (183 pages) ,
- Configuration manual (771 pages) ,
- Reference manual (226 pages)
Table of Contents
Advertisement
Status will be changed to Tx&Rx. To disable the LLDP-MED feature for the
corresponding port, please use no lldp med-status command.
Syntax
lldp med-status
no lldp med-status
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Enable the LLDP-MED feature for port 2:
TL-SG2424P(config)# interface gigabitEthernet 1/0/2
TL-SG2424P(config-if)# lldp med-status
lldp med-tlv-select
Description
The lldp med-tlv-select command is used to configure LLDP-MED TLVs to be
included in outgoing LLDPDU for the corresponding port. To exclude
LLDP-MED TLVs, please use no lldp med-tlv-select command. By default, All
TLVs are included in outgoing LLDPDU.
Syntax
lldp
[power-management] [all] }
no lldp med-tlv-select { [inventory-management] [location] [network-policy]
[power-management] [all] }
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Exclude "network policy" and "inventory" TLVs in LLDPDU outgoing from port 2:
TL-SG2424P(config)# interface gigabitEthernet 1/0/2
TL-SG2424P(config-if)# no lldp med-tlv-select network-policy
inventory-management
med-tlv-select
{
[inventory-management]
168
[location]
[network-policy]
Advertisement
Table of Contents
