Heat & Glo CERONA-42 Owner's Manual page 42

Model: Cerona-42
If the gas logs have been factory installed they should not need to be positioned. If the logs have been packaged separately,
refer to the following instructions.
CAUTION: Carefully remove the logs
from the packaging. Logs are fragile!
STEP 1.
LOG #1 (SRV2107-701):
Place log #1 over the back side of the burner
plate and slide forward until log hits the grate.
Log cut out should fi t over pilot bracket. See
Figure 12.13.
STEP 2.
LOG #2 (SRV2107-702):
Fit log #2 on the right side of the grate. The
log is formed so it will sit around the right grate
bar. Rest the top of the log on the fl at section
of log #1. See Figure 12.14
42
Figure 12.12
Figure 12.13
Figure 12.14
Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/08
Log Assembly: LOGS-Cerona42
5 5
4 4
2 2
1 1
FORM FITTED FORM FITTED
TO GRATE TINE TO GRATE TINE
1 1
6 6
3 3
2 2
2107-935