Securing And Leveling The Appliance; Installing Non-Combustible Facing Material - Heat & Glo CERONA-42 Owner's Manual

B. Securing and Leveling the Appliance
CAUTION
Sharp Edges
• Wear protective gloves and safety
glasses during installation.
WARNING
Fire Risk.
• Prevent contact with sagging, loose insulation.
• Do NOT install against combustible materials
such as exposed insulation, plastic and insulation
backer.
The diagram shows (Figure 7.2) the location of the nailing tabs
provided to secure the appliance to the framing members.
NAILING
TABS
Figure 7.2 Proper Positioning, Leveling and
Securing of a Appliance
• Place the appliance into position.
• Level the appliance from side to side and front to back.
• Shim the appliance, as necessary. It is acceptable to use
wood shims.
• Bend out nailing tabs on each side.
• Keep nailing tabs fl ush with the framing.
• Secure the appliance to the framing by using nails or
screws through the nailing tabs.
22 Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/08
WARNING
Fire Risk.
• ALWAYS maintain specifi ed
clearances around the appliance.
• Do NOT notch into the framing around the appliance spacers.
Failure to keep insulation, framing or other material away from
the appliance may cause fi re.
C. Installing Non-combustible Facing Material
WARNING
Fire Risk.
• Follow these instructions exactly.
• Facing materials must be installed properly to
prevent fi re.
• No materials may be substituted without
authorization by Hearth & Home Technologies.
• Center and attach top board to the framing members
(see Figure 7.3).
• Use fasteners from fastener packet (in manual bag) in
shaded areas (Figure 7.3).
• Use regular sheetrock screws in non-shaded areas (see
Figure 7.3).
APPLY
FASTENERS FROM
FASTENER PACKET
IN SHADED AREAS
Figure 7.3 Attaching Non-combustible Facing Material