iConyx IC2-R User Manual page 52

2
IC
Users Manual
The buttons located below the white Preset Listing area provide for a variety of functions.
The Load Preset button loads the selected Preset into the associated array's working memory.
The Delete Preset erases the selected Preset and the Delete All button erases all of the Presets.
The Reset Array button restores the Arrays DSP and beam steering settings to their original default settings.
The Save To Presets section allow you to save the DSP settings and beam steering information to a selected Preset. Use the up/down
arrows to select the desired Preset.
The Presets To / From File buttons allow you to Export (save) the Preset configuration to a file on your computer for future use or to Import
a Preset configuration you had previously saved. Pressing the Export button introduces the following Dialog screen which allows you to
select exactly what information will be exported.
The two Panel Control buttons serve two separate functions.
The Panel Button control with the padlock icon locks and
unlocks all the control buttons on the array control panel. In the
locked condition it prevents unauthorized personnel from mis-
adjusting the controls. The array controls are locked when the
padlock is closed.
The Panel Display control turns the array's digital readout
display off to prevent the display's red glow from being a
distraction. The display is turned on when the icon is outlined in
red. Note that the digital readout can also be turned On and Off using the Preset Up and Preset Down push buttons on the array's control
panel. Pressing both of these controls at the same time toggles the readout between On and Off.
When one is provided, an associated IC-RC1 Remote Preset Control allows users to select and change presets from a remote location
without the need for a computer. It's simple to use; select the desired Preset and then press the Green Enter button to load the Preset
into the associated array. The light will flash until the Preset is fully loaded and then
go out. More details on installing and operating the IC-RC1 can be found on page
52. Be aware that when the IC-RC1 is installed and connected it takes away preset
control from the controls on the rear of the array and from any remotely connected
computer.
Iconyx systems have facilities available for data communication via RS485. This
allows users to implement control and monitoring via third party controllers such as
those made by Crestron. For more information on controlling your Iconyx array using
a Crestron control system refer to the Crestron website at
http://www.crestron.com/tools_and_resources/programming_and_integration_re-
sources/integrated_partner_modules/default.asp?manufacturer_id=247
For information on initializing your Iconyx systems for third party RS485 based
control refer to page 61.
IC-RC1 Remote Preset Control
33
52