iConyx IC2-R User Manual page 50

At this point the changes you have made in beam steering have not been sent to the working memory (DSP) in the associated array
or stored as a Preset.
In the beam steering window, select either Send to Working Memory or Save to Preset. The two commands are in the lower right of
the beam steering window. Send to Working Memory will send the beam steering settings direct to the array's DSP and write over any
previous settings. Save to Preset will store the beam settings in the designated Preset. Note that the Beam Steering Presets control
only the beam steering data; EQ, compression, etc. configuration settings are controlled in the Control Mode.
If you attempt to leave Beam Steering without saving the setup information, a prompt will remind you that you need to save the set-
tings if you want to keep them.
Note that Presets can not be saved to an array in the virtual world. Presets can only be saved to real loudspeaker via the network.
PRESETS
IC 2 arrays can store up to 10 different configurations as Presets in the array's DSP memory.
For example, you might optimize one configuration for small events on the main audience
area and another for larger occasions when a balcony is used. The Presets include the beam
steering data, as well as gain, EQ ,compression, etc. settings. Switching between the preset
configurations is easy. They can be changed from either the rear of the array, from the control-
ling computer or, if one is provided a wall mounted remote control. Third party controllers,
such as those supplied by Crestron can also be used to configure the array and select presets
using the RS485 connection.
IC 2 Arrays include the following factory installed Presets.
On single IC 2 arrays:
Preset 10: is factory installed and locked to "Flat" for use in transducer testing and should not be used during normal
Preset 14: was installed by Quality Assurance during final performance testing at the factory and was not locked. It may
Presets 11, 12, 13, 15,16, 17, 18 & 19 are set aside for user installed presets.
On stacked IC 2 arrays;
Preset 20: is factory installed and locked to "Flat" for use in transducer testing and should not be used during normal
Preset 24: was installed by Quality Assurance during final performance testing at the factory and was not locked. It may
have been deleted and replaced by a user installed preset
Presets 21, 22, 23, 25, 26, 27, 28 & 29 are set aside for user installed presets.
The digital readout on the array's rear mounted control panel displays the number of the selected Preset.
50
operation.
have been deleted and replaced by a user installed preset
operation.
31