Table of Contents
Advertisement
B. Design and Installation Considerations
Heatilator B-type vent gas appliances are designed to
operate with all exhaust gases expelled to the outside of
the building, and combustion air pulled from the room.
Installation MUST comply with local, regional, state and
national codes and regulations. Consult insurance carrier,
local building inspector, fi re offi cials or authorities having
jurisdiction over restrictions, installation inspection and
permits.
Before installing, determine the following:
•
Where the appliance is to be installed.
•
The vent system confi guration to be used.
•
Gas supply piping.
•
Electrical wiring requirements.
•
Framing and fi nishing details.
•
Whether optional accessories—devices such as a fan,
wall switch, or remote control—are desired.
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage. For
assistance or additional information, consult a qualifi ed
service technician, service agency or your dealer.
C. Tools and Supplies Needed
Before beginning the installation be sure that the follow-
ing tools and building supplies are available.
Gloves
Tape measure
Pliers
Hammer
Voltmeter
Plumb line
Level
Manometer
1/2 - 3/4 in. length, #6 or #8 Self-drilling screws
High temperature caulking material
Noncorrosive leak check solution
Safety glasses
Framing material
Flat blade screwdriver
Phillips screwdriver
Electric drill and bits (1/4 in.)
Framing square
Reciprocating saw
Heatilator • Caliber Mesh BV Series • 4040-848 Rev G • 10/08
D. Inspect Appliance and Components
The following B-vent components are needed for installa-
tion.
•
Fireplace Box
•
Pipe Components
•
Firestops
•
Attic Insulation Shield
•
Elbows
•
Strapping
•
Roof Flashing or Chase Top
•
Termination Cap
•
Storm Collar
•
Carefully remove the appliance and components from
the packaging.
•
The vent system components and decorative doors and
fronts may be shipped in separate packages.
•
If packaged separately, the log set and appliance grate
must be installed.
•
Report to your dealer any parts damaged in shipment,
particularly the condition of the glass.
•
Read all of the instructions before starting the installation.
Follow these instructions carefully during the installation
to ensure maximum safety and benefi t.
WARNING! Risk of Fire or Explosion! Damaged parts
could impair safe operation. DO NOT install damaged,
incomplete or substitute components. Keep appliance dry.
Hearth & Home Technologies disclaims any responsibility for,
and the warranty will be voided by, the following actions:
•
Installation and use of any damaged appliance or vent
system component.
•
Modifi cation of the appliance or vent system.
•
Installation other than as instructed by Hearth & Home
Technologies.
•
Improper positioning of the gas logs or the glass
door.
•
Installation and/or use of any component part not
approved by Hearth & Home Technologies.
Any such action may cause a fi re hazard.
WARNING! Risk of Fire, Explosion or Electric Shock!
DO NOT use this appliance if any part has been under wa-
ter. Call a qualifi ed service technician to inspect the appli-
ance and to replace any part of the control system and/or
gas control which has been under water.
15
Advertisement
Table of Contents
