Install The Drivers & Software - Brother DCP-585CW Quick Setup Manual

Wireless Network
Install the Drivers & Software
(For Mac OS
12
Before you install
MFL-Pro Suite
a
Make sure your machine is connected to the
power and your Macintosh
be logged on with Administrator rights.
Important
Make sure there are no memory cards or a
USB Flash memory drive inserted.
13
Install MFL-Pro Suite
a
Put the supplied CD-ROM into your CD-ROM
drive.
b
Double-click the Start Here OSX icon to install.
c
Choose Wireless Network Connection, and
then click Next.
d
Click on the Checked and confirmed check
box, and then click Next.
Follow the on-screen instructions.
Note
Please wait, it will take a few seconds for the
software to install. After the installation, click
Restart to finish installing the software.
e
The Brother software will search for the Brother
device.
Note
• If your machine is not detected, go to step 10
on page 15 and setup the wireless connection
again.
• If you are using WEP and the LCD displayed
'Connected' but your machine is not found,
make sure you entered the WEP key correctly.
The WEP key is case sensitive.
®
X 10.2.4 or greater)
®
is ON. You must
Macintosh
f
When this screen appears, click OK.
®
For Mac OS X 10.3.x or greater, the
installation of MFL-Pro Suite is now
complete.
g
®
For Mac OS X 10.2.4 to 10.2.8 users,
click Add.
h
Make the selection shown below.
i
Choose XXX-XXXX (where XXX-XXXX is your
model name), and then click Add.
j
Click Print Center, then Quit Print Center.
The installation of MFL-Pro Suite is now
complete.
The installation is now
Finish
complete.
®
19