Routing - NetComm LIBERTY SERIES User Manual

7.4 Routing

Static Route and Dynamic Route settings can be found in the Routing link as illustrated below.
7.4.1 Static Route
The Static Route screen displays the configured static routes. Click the Add or Remove buttons to change settings.
Click the Add button to display the following screen.
Enter Destination Network Address, Subnet Mask, Gateway IP Address and/or WAN Interface. Then click Save/Apply to add the entry to the
routing table.
7.4.2 Dynamic Route
To activate this option, select the Enabled radio button for Global RIP Mode.
To configure an individual interface, select the desired RIP version and operation, followed by placing a check in the Enabled checkbox for
that interface. Click Save/Apply to save the configuration and to start or stop dynamic routing.
HSPA+ WIFI ROUTER WITH VOICE
40
User Guide YML10WVR2
www.netcommlimited.com