Connection And Preparation; Power Supply - Grundig RRCD 3760 WEB Manual

12

CONNECTION AND PREPARATION

Power supply

Mains operation
Check that the mains voltage on the type plate (on the bottom of the
device) corresponds to your local mains supply. If this is not the case,
contact your specialist dealer.
1 Plug the power cord supplied into the
of the device.
2 Plug the power cord into the wall socket.
Caution:
The device is connected to the mains with the power cord. Pull out
the power plug when you want to completely disconnect the
device from the mains.
Unplug the mains plug to disconnect the device from the mains.
Make sure the power plug is easily accessible during operation
and not hindered by other objects.
The socket should be directly by the device and freely accessible.
Battery operation
1 Open the battery compartment by pressing »OPEN« underneath
the device and pushing the lid in the direction of the arrow
(» S «).
2 Insert six batteries (6 x 1.5 V, type LR20/AM1/D size), observ-
ing the polarity marked in the battery compartment.
Note:
During battery operation in standby mode, it is not possible to
switch the device on with the remote control.
Notes:
Do not expose the batteries to extreme heat, caused for example
by direct sunlight, heaters or fire.
Remove the batteries when they are flat or when you know that
the device will not be used for a long period of time. The manu -
facturer accepts no liability for damage caused by leaking
batteries.
The batteries are switched off during mains operation.
Environmental note:
Batteries, including those which do not contain heavy metal,
should not be disposed of with household waste. Always dispose
of used batteries in accordance with local environmental
regulations.
»AC ∼« socket on the back