Lever For Hydraulic Lift Of Attachments - Husqvarna P520 D Operator's Manual

Lever for hydraulic lift of
attachments
The lifting lever is used to put the cutting unit in either the
transport or mowing position when hydraulic pressure is
available.
The lever has four different positions.
• Position 1 is the neutral position.
• Position 2 lowers the cutting unit with spring return to the
neutral position
• Position 3 is floating where the lever stops. The unit is
lowered to the automatically floating position, which
means that the cutting unit follows the contours of the
ground.
• Position 4 raises the cutting unit with spring return to
neutral position.
When cutting the lever should be set directly to the floating
position (3).
Lifting the Cutting Unit (Transport
Position)
Stop the blades by pressing the stop button.
Pull the lever backwards to engage the transport position. The
unit is then raised.
The cutting unit can be raised slightly with the blades rotating.
This is to facilitate the mowing of extremely tall grass or
uneven surfaces.
PRESENTATION
Lowering the Unit (Mowing Position)
Move the hydraulic lifting lever forwards to engage the cutting
position.
When cutting the lever should be set directly to the floating
position (3).
Controls for operating the cutting unit
blades
The cutting unit can be started only when the driver is sitting
in the seat.
• Pull out the lever to engage the drive of the blades.
• Push in the lever to disengage the blades.
When the safety circuit has stopped the drive to the cutting
unit, the control must be pushed and pulled out again to start
the blades.
The safety circuit is triggered and the cutting unit is stopped
in the following cases:
• When the driver leaves the seat with the blades engaged.
There is a short delay to prevent stopping if the driver
bounces on the seat.
– 13
English