Check the battery
WARNING! Lead-acid batteries produce
!
explosive gases. Avoid sparks, open flames
and smoking close to batteries. Always wear
protective glasses in the vicinity of batteries.
The machine is equipped with a maintenance-free battery.
The battery has a service window showing different colours.
•
White = Charge battery
•
Green = OK.
•
Red = Change battery.
Clean the battery and holder with soap/water solution.
A discarded or replacement battery should be handled as
hazardous waste.
The Cutting Unit Components
The components mentioned are:
A Pin
B Link joint
C Cutting unit bracket
D Clipping height adjusters
E Universal drive shaft with quick connectors
E Attachment point for service position
G Belt cover
26 –
English
Maintenance
Removing the cutting unit
!
1 Place the machine on a flat surface and apply the parking
brake.
2 Remove the universal drive shaft completely. Slide the
ring sideways to release the quick coupling and the
universal drive shaft can be pulled from the shaft pin.
3 Start the engine and raise the cutting unit to the max
position.
4 Turn off the motor.
5 Remove the pins on both sides.
6 Lower the cutting unit to the float position
7 Remove the pins from the shafts and remove the shafts
from the link joints.
!
8 The cutting unit is now free.
WARNING! Never leave the universal drive
shaft of the machine with one end loose. If
the engine is started, damage can occur.
WARNING! If the help function is connected,
the lift arms move with great force when the
pins are loosened. Observe caution to avoid
trapping your hand.