Healthrider HREL2005.0 User Manual page 6

5. While another person holds the Console (5) near the
Console Bracket (26), insert the console cable into
the Console Bracket and down through the Upright
(2). Next, connect the console wire to the Upper Wire
Harness (55). Then, connect the ground wire to the
Console Bracket with an M4 x 16mm Screw (66).
Insert the Wire Harnesses down into the Console
Bracket.
Attach the Console (5) to the Console Bracket (26)
with three M4 x 16mm Screws (66). Be careful to
avoid pinching the cable and the wires.
6. While another person holds the Upright (2) near the
Frame (1), connect the Upper Wire Harness (55) to
the Lower Wire Harness (65). Next, connect the con-
sole cable to the Lower Cable (15) in the following
way:
• See drawing A. Pull up on the metal bracket on the
Lower Cable (15), and insert the tip of the console
cable into the wire clip inside of the metal bracket.
• See drawing B. Firmly pull the console cable and
slide it into the metal bracket on the Lower Cable
(15) as shown.
• See drawing C. Using pliers, squeeze together the
prongs on the upper end of the metal bracket.
Push the excess cable and wire up into the Upright
(2). Set the holes in the front of the Upright over the
studs in the Front Stabilizer (3). Be careful to avoid
pinching the cables and the wires. Finger tighten
two M10 Nylon Locknuts (29) onto the studs.
Carefully tip the elliptical exerciser onto one side, and
attach the Upright (2) to the Frame (1) with two M10 x
68mm Carriage Bolts (19) and two M10 Nylon
Locknuts. Tighten all four M10 Nylon Locknuts.
See step 2 on page 5. Tighten the M10 x 25mm
Button Screws (21).
5
Ground
Wire
66
6
2
29
Console
Cable
15
3
A B
Metal
Bracket
Console
Console
Cable
15
6
Console 5
Cable
66
Console
55
Wire
26
66
2
29
55
65
1
19
C
Console
Cable
Cable
15
15