What To Do If - Zanussi ZOP38903 User Manual

2
1
7
Carefully lift (step 1)
and remove (step 2) the
glass panels one by one.
Start from the top panel.
Clean the glass panels with water and soap. Dry the glass
panels carefully.
Installing the door and the glass panels
When the cleaning is completed, install the glass panels
and the oven door. Do the above steps in the opposite se-
quence.

What to do if...

Warning! Refer to "Safety information" chapter.
Problem
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven lamp does not operate.
18
Possible cause
The appliance is deactivated.
The clock is not set.
The necessary settings are not set.
The automatic switch-off is on.
The Child Lock is on.
The fuse in the fuse box is released.
The oven lamp is defective.
3
1 2
Make sure that you put the
glass panels (1, 2 and 3)
back in the correct se-
quence. The middle panel
(2) has a decorative frame.
The screen-printing zone
must face the inner side of
the door. Make sure that
after the installation the
surface of the glass panel
frame (2) on the screen-
printing zones is not
rough when you touch it.
Activate the appliance.
Set the clock.
Make sure that the settings are correct.
Refer to "Automatic switch-off".
Refer to "Deactivating the Child Lock".
Do a check of the fuse. If the fuse is re-
leased more than one time, contact a
qualified electrician.
Replace the oven lamp.
Make sure that you install
the top panel in the seats
correctly.
Remedy
www.zanussi.com