Healthrider C865e elliptical exerciser HRE69940 User Manual page 8

Healthrider c865e elliptical exerciser
Table of Contents

Advertisement

7. Apply a small amount of the included Teflon
to a paper towel. Rub a thin film of the lubricant onto
each Upper Body Leg (31).
Identify the Left Upper Body Arm (107), which is
marked with a sticker. Slide the Left Upper Body Arm
onto the left Upper Body Leg (31). Slide the Right
Upper Body Arm (85) onto the right Upper Body Leg
(not shown). Make sure that the Upper Body Arms
are on the correct sides. Next, slide an Axle Cover
(26) onto the post on each Upper Body Arm.
Apply a generous amount of the included grease to the
Arm Axle (19). Insert the Arm Axle into the Upright (2),
the right Axle Cover (26), and the Right Upper Body
Arm (85). Next, push the Arm Axle into the Upright until
the left end of the Arm Axle is flush with the left
side of the Upright. Then, raise the Left Upper Body
Arm (107), and insert the Arm Axle into the left Axle
Cover (26) and the Left Upper Body Arm.
Using the included pedal tool, tap two Push Nuts (24)
about 1/8" onto each end of the Arm Axle (19). Make
sure that the Push Nuts are turned as shown in the
inset drawing. Note: It may be helpful if another person
holds a block of wood against one end of the Arm Axle
while you tap Push Nuts onto the other end.
Press the small tabs on the Upper Body Arm Caps (91)
into the two Axle Covers (26).
8. Have another person hold the Console (17) near the
Upright (2).
Connect the Upper Wire Harness (95) to the wire har-
ness on the Console (17). Connect the Pulse
Extension Wire (101) to the pulse wire on the Console.
Next, locate the two ground wires that are attached to
the Upright (2). Connect the ground wires to the two
smallest wires on the Console.
Carefully insert all excess wiring up into the Console
(17) and down into the Upright (2). Attach the Console
to the Upright with four M4 x 16mm Screws (98).
(Note: The Screws may be found in the console box.)
Be careful to avoid pinching the wires.
®
lubricant
7
91
24
Pedal
Tool
8
Do not pinch
the wires
during this step.
98
8
2
107
19
26
Grease
Tube
31
Lubricate
24
19
17
101
95
Ground
98
Wires
2
85
91
24
26

Advertisement

Table of Contents
loading

This manual is also suitable for:

C865e

Table of Contents