Clock Set Manually - Light O Rama DC-MP3 User Manual

LightORama ► Light-O-Rama Control Panel. The
Light-O-Rama light bulb icon will appear in the
system tray on the lower right of your screen.
Start the Hardware Utility by right-clicking the Light-
O-Rama Control Panel light bulb and selecting
Hardware Utility from the menu.
Click the LOR MP3 tab.
Click the Only place SET TIME file on the SD Card
button. You will see the following window:
Set the time you want to put on the SD card and
select the SD card drive from the Select SD card
drop-down menu. Click the Write File to SD button.
Put this card in the DC-MP3 to set its real time clock.
When the SD card is placed in the DC-MP3, the E, R
& C LEDs will chase for about 10 seconds while the
time is being set. The time is only set the first time
the SD card is inserted into the DC-MP3.
Note that the DC-MP3 should be powered up for at
least 15 minutes to insure that the backup capacitor
for the real time clock is fully charged.
Page 17
DC-MP3 DC-MP3

Clock Set Manually

This section describes how to set the DC-MP3's real
time clock manually. You must have:
• At least version 2 of the DC-MP3 firmware,
see the section DC-MP3 Firmware Versions
• No SD card in the DC-MP3
Note the current position of the Selector Switch so
you can put it back after setting the time.
Set the Selector Switch to 'F' and briefly press the
Reset button
The red E LED will come on steady to indicate Time
Set Mode.
The yellow R LED will blink a number of times that
corresponds to the time field being set.
Set Day of Week: yellow R LED blink pattern is 1
blink, pause, repeat. Use the Selector Switch to set
the day of the week. Sun=1, Mon=2, Tue=3, Wed=4,
Thu=5, Fri=6, Sat=7. Briefly press Reset Button.
Set First Digit of Hour: yellow R LED blink pattern
is 2 blinks, pause, repeat. This is a 24 hour time so
the hour will be a number between 00 and 23.
Midnight is 00, 1 AM is 01, noon is 12, 4 PM is 16.
Use the Selector Switch to set the first digit of the
hour and briefly press the reset button.
Set Second Digit of Hour: yellow R LED blink
pattern is 3 blinks, pause, repeat. Set the Selector
Switch to the second digit of the hour and briefly
press the reset button.
Set First Digit of Minute: yellow R LED blink
pattern is 4 blinks, pause, repeat. Minutes range
Page 18