Show Programming (Hardware Utility >1.6.4) - Light O Rama DC-MP3 User Manual

for information on determining and upgrading your
firmware.
The Simple Show Builder process takes only a few
minutes in a small number of self-explanatory
screens. Simple Show Builder is available for
download at www.lightorama.com
Software Downloads. Click the Download button to
the left of Simple Show Builder and run the installer.
Use Windows Explorer to run the Simple Show
Builder by double clicking it. The path to it is usually:
C:\Program Files\Light-O-Rama\LORSimpleShowBuilder.exe
Show Programming
(Hardware Utility >1.6.4)
This section describes how to use Hardware Utility
versions 1.6.4 and later to set up, schedule and
configure the input triggers for shows on the DC-
MP3. You must have:
• At least version 3 of the DC-MP3 firmware,
see the DC-MP3 Firmware Versions section.
• Hardware Utility version 1.6.4 or later, see the
Hardware Utility Versions section.
• The USB SD card reader/writer plugged into a
USB port on your PC with the SD card in it, or
have the SD card in your machine's built in
reader/writer
• It is not necessary to have the DC-MP3
connected to your PC to transfer a set of
shows to the SD card
Start the LightORama Control Panel if it is not
running by clicking start ► All Programs ►
LightORama ► Light-O-Rama Control Panel. The
Page 21
DC-MP3
► Support ►
DC-MP3
Light-O-Rama light bulb icon will appear in the
system tray on the lower right of your screen.
Start the Hardware Utility by right-clicking the Light-
O-Rama Control Panel light bulb and then selecting
Hardware Utility from the menu. You will see the
following window:
Click the LOR MP3 tab on the upper left and you will
see this window:
Page 22