Table of Contents
Advertisement
from 00 to 59. Set the Selector Switch to the first
digit of the minute and briefly press the reset button.
Set Second Digit of Minute: yellow R LED blink
pattern is 5 blinks, pause, repeat. Set the Selector
Switch to the second digit of the minute and briefly
press the reset button.
The E, R and C LEDs will chase a number of times
to indicate that the time has been successfully set.
Place the Selector Switch back in its original position
and press the Reset button.
Page 19
DC-MP3
DC-MP3
Show Programming Overview
There are two ways to create an SD card for the DC-
MP3.
1. Simple Show Builder – this application
creates a single, scheduled, non-interactive
show. It is simple and intuitive to use.
2. Hardware Utility – this application allows
access to the full capabilities of the DC-MP3.
Multiple shows with scheduling and
interaction are possible.
The next four sections explain how to use these
tools to create show(s) on the SD card.
There are three Hardware Utility version sections.
The first one describes programming the DC-MP3
where scheduling and interactive trigger inputs are
supported. The second one is for older versions of
the Hardware Utility and/or DC-MP3 firmware where
trigger inputs are not supported, but scheduling is.
The final Hardware Utility section describes
programming the initially released DC-MP3 whose
firmware only supported one unscheduled show.
Show Programming (SimpleShowBuilder)
Simple Show Builder is a Light O Rama application
that greatly simplifies the creation of a show on the
SD card for the DC-MP3. It allows you to create one
scheduled show consisting of a list of musical and
non-musical sequences without using the Hardware
Utility. This show can not use interactive triggers.
Your DC-MP3 must have firmware version 2.0 or
later. See the DC-MP3 Firmware Versions section
Page 20
Advertisement
Table of Contents
