Trouble Shooting. 1.65 - Hayter LT324 Operator's Manual

1.65
TROUBLE SHOOTING
When using the following chart it may be found that overhaul of major components or hydraulic
pressure adjustments are necessary. In this case it is recommended that your dealer make these repairs as
he is properly equipped to do this work.
WARNING: PREVENT ACCIDENTS - ALWAYS Apply the parking brake, switch off the engine
and remove the ignition key before attempting to work on the mower.
PROBLEM
Engine will not start
with ignition key.
For all other engine problems, refer - ENGINE HANDBOOK.
Flat Battery.
TROUBLE SHOOTING
POSSIBLE CAUSE
Transmission neutral interlock switch
not energised.
Parking brake interlock switch not ener-
gised.
Cutterhead drive interlock switch not
energised.
Faulty electrical connection.
Terminal connection
loose or corroded.
Loose or defective
alternator belt.
Defective battery.
Electrical short circuit.
1.65
REMEDY
Remove foot from for-
ward/reverse pedals.
Check setting of transmis-
sion neutral interlock switch.
Operate parking brake
lever to the ON position
Check setting of parking
brake interlock switch.
Move cutterhead drive
switch to the 'OFF' position.
Check setting of cutterhead
interlock switch.
Trace and correct fault.
Clean and tighten terminal
connections.
Recharge battery.
Re-tension or replace drive
belt, refer - ENGINE
HANDBOOK.
Recharge battery.
Replace battery.
Trace short circuit and
make good.
924916KG251004