Table of Contents
Advertisement
MOWER MAINTENANCE
Cutterblade Assembly
Assemble the cutterblade (1) with the turned up edges facing towards
the engine. Secure the cutterblade using the friction washer (2) and new
fixing bolt (3) and tighten to a torque of 54Nm.
1
To prevent accidents never reuse the original fixing bolt.
2
3
Cutterblade Sharpening
A slightly worn cutterblade may be re-sharpened. Both blade edges
must be sharpened equally to ensure balance. Sharpen the cutterblade
every 25 mowing hours or more frequently if conditions require.
Remove the cutterblade from the mower and clean using a brush and
water. Inspect the cutterblade for signs of damage.
Sharpen both cutting edges with a flat file to restore performance.
Ensure that the cutterblade is balanced. Use a screw driver with a
round shaft to support the cutterblade through its centre hole. Hold the
cutterblade horizontal and then release. A balanced cutterblade will
remain horizontal.
If the cutterblade is not balanced the heavy end will rotate downwards.
Sharpen the heavy end until the cutterblade is correctly balanced.
1.26
Advertisement
Table of Contents
