Table of Contents
Advertisement
Function
Signal Processors
Interfaces
Telephony Interface
Network Interface
RS-232 Interface
PCI Bus
LED Indicators
LED Indications on Front
Panel
Connectors & Switches
Rear Panel
Trunks
1 to 8 and 9 to 16
Ethernet 1 and 2
RS-232
Physical
Physical
Supply Voltages and
Power Consumption
(typical)
Environmental
Cooling
Hot Swap
Type Approvals
10
The following Balun adaptors were tested and certified by 3Com:
Manufacture Name: AC&E
Manufacture Name: RIT
388
Specification
3Com AC486 VoIP DSP based on:
TI DSP TMS5541 – each core at 133 MHz
1, 2, 4, 8 or 16 E1/T1/J1 Balanced 120/100 ohm, or 75 ohm using a BNC to
RJ-45 dual E1/T1 G.703 Balun adapter
Two 10/100 Base-TX, half or full duplex with auto-negotiation
RS-232 Terminal Interface. DB-9 connector on rear panel (available only on
the 1, 2 and 4-span configuration).
33 MHz, 32 bit, slave mode (PICMG 2.0 revision 2.1)
Power, ACT/Fail, T1/E1 status, LAN status, Swap ready indication
Two 50-pin female Telco connectors (DDK57AE-40500-21D) or 8 RJ-48c
connectors for trunks 1 to 8 only
Two 10/100 Base-TX, RJ-45 shielded connectors
Console port - DB-9
6U single cPCI slot. PICMG 2.0, R2.1 and R2.16 and R.3.0 CompactPCI™
card
480 channels
40.7 W, 3 A at 5 V, 7.8 A at 3.3 V
240 channels
24 W, 1.5 A at 5 V, 5 A at 3.3 V
120 channels
18.4 W, 0.9 A at 5 V, 4.2 A at 3.3 V
Humidity: 10 to 90% non-condensing
500 LFM at 50o C Ambient temp supporting 480 ports, 400 Linear Feet per
Minute (LFM) at 50o C Ambient temp supporting 400 ports
300 LFM at 50o C Ambient temp supporting 240 ports
Full hot swap supported boards
Part Number: B04040072
Part Number: R3712271
10
.
V6100 and V7122 User Guide
Advertisement
Table of Contents
