HP 9000 rp7440 Quickspecs page 10

QuickSpecs
Configuration
Core I/O Loading Rules Core I/O Loading Rules Core I/O Loading Rules Core I/O Loading Rules
Internal Disk Drives Internal Disk Drives Internal Disk Drives Internal Disk Drives
Internal Disk Drive Specifications Internal Disk Drive Specifications Internal Disk Drive Specifications Internal Disk Drive Specifications
Event notification to system console, e mail, pager, and/or HP Response Centers
Automatic hardware protection of critical environmental problems
Access to management interface and console(s) on LAN failure (modem required)
Remote resetting of hardware partitions
Forward progress indicator (Virtual front panel)
Out of band Manageability and PDC firmware update
Configure manageability and console security
SSL
External Management/Console LAN port: External Management/Console LAN port: 10/100Base-T LAN port using an RJ-45 connector.
External Management/Console LAN port: External Management/Console LAN port:
One External SCSI ports: One External SCSI ports: One External SCSI ports: Ultra320 LVD SCSI port for connections to mass storage or media. (A One External SCSI ports:
second U320 external port only available when internal drive off of LAN/SCSI is connected to
Smart Array).
Two External 1 GbE LAN ports.
Access to internal peripheral bay: Access to internal peripheral bay: Access to internal peripheral bay: Access to internal peripheral bay: The HP 9000 rp7440 Server internal peripheral bay is located
at the top front of the system chassis. The peripheral bay holds up to four low profile hot plug
disks and one half height removable media device (one half height bay supports two devices in
the case of optional slim line DVDs). Each HP 9000 rp7440 Server core I/O board set contains
dual channel Ultra320 SCSI controller chips that support the SCSI devices in the internal
peripheral bay. Each core I/O board set supports two internal disks. It is important to note that
separate controllers and SCSI busses manage the two disks supported by the primary and
secondary core I/O set (This is a change from the previous architecture in sx1000 based servers).
If use of more than two internal disks is needed, the HP 9000 rp7440 Server will require both core
I/O sets.
Minimum of one Core I/O board set (primary) must be purchased with each HP 9000 rp7440
Server
Load the Primary (1) MP/SCSI board into slot 1 and the LAN SCSI board into I/O cabinet 1 (slot
8).
MP/SCSI slot 0 and I/O cabinet 0 corresponds to Cell Board slot 0. MP/SCSI slot 1 and I/O
cabinet 1 corresponds to Cell Board slot 1.
A cell board must be installed in slot 0 to enable use of Core I/O 0. Likewise, a cell board must
be installed in slot 1 to enable use of Core I/O 1.
Access to two internal disk drives and one half height removable media bay is enabled with the
installation of the first Core I/O board set (Primary).
The optional second Core I/O board set (secondary) must be ordered to enable hardware
partitioning
The optional second Core I/O board set (secondary) must be ordered to enable access to the
third/fourth internal disks.
The optional second core I/O board set (secondary) must be ordered to enable using the optional
slim line DVDs.
HP 9000 rp7440 Server supports up to four internal low profile hot plug disk drives.
DA - 12696 North America — Version 4 — March 3, 2008
HP 9000 rp7440 Server HP 9000 rp7440 Server HP 9000 rp7440 Server HP 9000 rp7440 Server
Page 10