Connecting The Cables - Compaq LE1902 User Manual

Connecting the Cables

1. Place the monitor in a convenient, well-ventilated location near the computer.
2. Remove the cable management clip from the pedestal by pulling outward on the two sides of the
clip (1) then lifting the clip off the pedestal (2).
Figure 3-3
3. Connect a VGA signal cable or DVI-D signal cable (select models).
NOTE:
video mode is determined by the video cable used. The monitor will automatically determine
which inputs have valid video signals. The inputs can be selected by pressing the
button on the front panel or through the On-Screen Display (OSD) feature by pressing the
button.
●
For analog operation, use the VGA signal cable provided. Connect the VGA signal cable to
the VGA connector on the rear of the monitor and the other end to the VGA connector on
the computer.
●
For DVI digital operation, use the DVI-D signal cable provided. Connect the DVI-D signal
cable to the DVI connector on the rear of the monitor and the other end to the DVI
connector on the computer.
ENWW
Removing the Cable Management Clip
The monitor is capable of supporting either analog or digital input (select models). The
+/source
Menu
Connecting the Cables 7