Table of Contents
Advertisement
●
Dynamic Contrast Ratio On—Indicates that Dynamic Contrast Ratio has been turned on. This
occurs if Dynamic Contrast Ratio is turned on in the Image Control OSD menu.
●
Dynamic Contrast Ratio Off—Indicates that Dynamic Contrast Ratio has been turned off. This
occurs if Dynamic Contrast Ratio is turned off in the Image Control OSD menu.
●
Theft Mode Enabled—Indicates that theft deterrence mode has been activated. Theft
deterrence is an optional feature that can be set up in HP Display Assistant. Theft deterrence
mode is triggered if both the power and display cables have been disconnected from the
monitor, the monitor is reconnected to a different computer, and the theft deterrence PIN number
is not entered within the elapsed time. When the monitor is in theft deterrence mode, all front
panel buttons are disabled other than the power button.
Sleep Timer Mode
The Sleep Timer mode is an energy-saving feature that enables you to set a time for the monitor to
power on and off at the same time every day. This also extends the life of the backlight bulbs in the
monitor. The Sleep Timer has five settings:
●
Set Current Time
●
Set Sleep Time
●
Set On Time
●
Timer: On/Off
●
Sleep Now
To set the timer:
1.
Press the
2.
Scroll down and highlight Management.
3.
Press the
4.
Scroll down and highlight and select Sleep Timer > Set Current Time.
NOTE:
Time. Note that the time is displayed in a 24–hour clock format. For example, 1:15 p.m. is
displayed as 13 hours 15 minutes.
A power failure or loss of power to the monitor will cause the timer to reset to 00:00. If this
occurs, you will need to reset the sleep timer mode.
5.
Press the
6.
Press the
7.
Press the
8.
Press the
9.
Press the
10.
After setting the current time, the highlight automatically skips to Set Sleep Time. Repeat steps
6 through 9 to set Sleep Time.
11.
If you do not want to set Sleep Time, press the
to exit the menu.
24
Chapter 4 Operating the Monitor
Menu
button on the monitor front panel to display the OSD Menu.
OK
button to select Management.
You must set the current local time before you reset the time for Sleep Time or On
OK
button once to enter the adjustment mode for hours.
-
(Minus) or
+
(Plus) button to adjust the hour.
OK
button again to enter the time for minutes.
-
(Minus) or
+
(Plus) button to adjust the minutes.
OK
button to lock in the time chosen.
OK
button twice, then select Save and Return
ENWW
Advertisement
Table of Contents
