Connecting The Display To Your Computer - Compaq 7020 User Manual

Installation

Connecting the Display to Your Computer

1. Power off your computer.
2. Connect one end of the signal cable to the monitor's VGA
port or DVI port (digital models only). (See Fig. 1-5)
3. Connect the other end of the signal cable to the VGA port
or DVI port on your PC.
4. Make sure both connections are secure.
Figure 1-5
WARNING: This device must be connected to an off-the-shelf
video cable in order to comply with FCC regulations. A ferrite-core
interface cable is included in the monitor package. This device will
not be in compliance with FCC regulations when a non-ferrite-core
video cable is used.
1-6 Compaq 7020 Flat Panel Monitor User's Guide