External Controller; Rs-232C Connector; Trigger Output Jack; Master Trigger Input Jack - Denon POA-3012CI - Multi-Zone Audio Distribution Power Amplifier Owner's Manual

ENGLISH
···········ON
····STANDBY
The "POWER CONFIGURATION" setting is valid
at the time of a "MASTER TRIGGER ':
Voltage input to the MASTER TRIGGER input
terminal and operating status of the POA-3012CI:
t---tt=~~U
At DC 3 - 30 V········· ON
At DC 0 V·· STANDBY
Master tl'iggerinput jack
The ZONE TRIGGER ON MODE setting is valid at
the time of a "TRIGGER IN':
Voltage input to the TRIGGER IN input terminal
and operating status of the power amplifier of
each ZONE:
At DC 3 - 30V
At DC OV .
*
If you wish to control the POA-3012CI from
an external controller using the RS-232C
connector, perform the operation below
beforehand.
G) Turn the POA-3012Cl's power.
®
Turn off the POA-3012CI's power from the
I--ii'+-~:'i-i
external controller.
QJ
Check that the POA-3012CI is in the standby
mode.
RS.2~2C
C()11"ector
This connector is used for an external controller.
The power of an external device equipped with
a trigger input jack can be turned on and off in
association with operations on the POA-3012CI.
• Output level: 250 mA/12 V
Check the trigger input conditions of the
connected device.
• If the trigger input level of the connected device
is higher than 250 mA/12 V and depending on
the short-circuiting conditions. the POA-3012Cl's
protection circuit may be activated, in which
case "TRIGGER OUT OVER LOAD" appears on
the display. If this happens, turn off the POA·
3012CI's power and disconnect the connected
device.
I
Extemal
Controller
I
9