Using The Audio/Video Input Jacks - Sanyo ST-21XS2S Owner's Manual

USING THE AUDIO/VIDEO INPUT JACKS

You can connect your VCR, camcorder, video game, stereo system, etc. directly to the
TV using the Audio and Video jacks. Be sure to switch off TV and external equipment
before connecting cables. Make sure all cable connectors are fully seated on the jacks to
avoid possible signal loss and audio hum. (Cables are not supplied.)
CONNECTING AUDIO VIDEO INPUT JACKS
Connect the video output from the external equipment to the TV's video input jack.
•
Stereo (R/L) audio: Connect the right and left audio output from the external equipment to
•
the TV's right and left audio input jacks.Then select "STEREO" channel of the audio
channel in the TV set with the AUDIO menu setting in AV mode.
If the external audio signal is a monaural one in this connection, please use "Mono to
Stereo Adapter" (not supplied) and connect to TV set. Note: AV stereo in AV mode always
fixed on "STEREO" channel
Mono (single jack) audio: Connect the audio output from the external equipment to the
•
TV's left (L) audio input jack.
BACK OF VCR
OUTPUT Y C
S-VIDEO R–AUDIO–L VIDEO
FRONT AV JACKS
CAMCORDER
24
IN
CH3
C
B R
CH4
OUT
To watch video input picture, select AV1
position by pressing the TV/AV key.
To watch video
input
select
position
pressing
TV/AV key.
Note: Model ST-21SF1 / ST-21SF1K is not
equipped with Front AV2 input terminal
CABLE
AV1
BACK OF TV
picture,
AV2
by
the
AV2
INPUT MONITOR OUT
AV1/DVD
C R R
R
(MONO)
C L L
B
ANT. 75Ω
Y
V
I
D
E
VIDEO
O
ANTENNA
TERMINAL
A/V JACKS