Table of Contents
Advertisement
Go to USER TOOL settings
Choose "System Settings"
Scroll to "Power Saving"
Set to "off"
Exit User Codes
Q:
I have entered a custom page size but the print job comes out too
small?
A:
It is possible that you have input the page size incorrectly. The Unit of
measurement used for page size is 0.01 inches or 0.1 mm. This means
that you need to multiply by a factor of 100 to get the correct size in
inches or a factor of 10 to get the correct size in mm.
Q:
The image I am getting is larger than it should be and has fine hori-
zontal lines running through it?
A:
It is possible that you have entered a page size greater than the maxi-
mum image area of the Digital Duplicator connected to the UC5. Check
the maximum page size of your Digital Duplicator and the page size
entered in the UC5. Also check that you have used the correct multipli-
cation factor for your page measurements. (see FAQ above).
Q:
When I define a custom page size the image I get is printed trans-
verse (across) the drum.
A:
The "width" value in the page setup refers to the size of the leading
edge of the page. The leading edge is the edge that feeds into the
Digital Duplicator. The "length" value refers to the size of the side of
the page. By entering a "width" value greater than the "length" value
the image will be positioned transverse on the drum. This means that
the operator will need to use the longest edge of the sheet as the lead-
ing edge.
37
Advertisement
Table of Contents
