Frequently Asked Questions - Ricoh UC5 Operator's Manual

Frequently Asked Questions

Q: How far can I have the UC5 from the computer?
A: The official specification for parallel cable recommends a length not
greater than 3 feet (1 metre).
Q: How far can I have the UC5 from the Digital Duplicator?
A: The official specification allows for 6 feet (appro.. 2 metres) cable. This
cable is supplied with the UC5. The potential for line communication
problems are greater the farther the UC5 is away from the computer.
Q: How many computers can you run from the UC5?
A: One IBM or compatible connected to the parallel port.
Q: Will the UC5 work with a laptop or notebook computer?
A: Yes, all computers connect to the UC5 as if it were a standard compu
ter printer. The GDI driver will need to be installed in each computer.
Q: Is any special wiring required for the UC5?
A: No, it will work on 110 or 220 volt systems by using the appropriate
power cord.
Q: How much RAM memory does the UC5 have?
A: It comes standard with a maximum 16 megabytes RAM.
Q: What if my file size is over 1 megabyte? Will the UC5 be able to
print the file?
A: Yes, the UC5 is not limited by your file size. If your PC can process the
file, the UC5 can print it to the Digital Duplicator.
Q: Can you add additional memory?
A: No, the UC5 comes with maximum memory installed as standard.
Q: Must you configure all software when you install the UC5?
A: No. Once the driver is installed in any operating system on the compu-
ter, all software application programs can use it.
34