Troubleshooting - DeLonghi ECAM28.46X Instructions For Use Manual

GENERAL ALARM
EMPTY CIRCUIT FILL CIRCUIT
alternating with
Hot water press OK
REPLACE FILTER
SET DIAL TO CLEAN
INSERT WATER SPOUT
INSERT MILK CONTAINER

TROUBLESHOOTING

Below is a list of some of the possible malfunctions.
If the problem cannot be resolved as described, contact Customer Services.
PROBLEM
The coffee is not hot
The coffee is thin or not creamy
enough.
The coffee is delivered too slowly or a
drop at a time.
The inside of the appliance is very dirty.
The water circuit is empty.
The water filter is exhausted.
Milk has been delivered recently and the tubes
inside the milk container must be cleaned.
The hot water spout is not inserted or is
inserted incorrectly.
The milk container is not inserted correctly.
POSSIBLE CAUSE
The cups were not preheated.
The infuser has cooled down because
2/3 minutes have elapsed since the last
coffee was made.
Low coffee temperature is set.
The coffee is ground too coarsely.
The coffee is unsuitable.
The coffee is ground too finely.
Clean the inside of the appliance thoroughly,
as described in the section "Cleaning and
maintenance". If the message is still displayed
after cleaning, contact a service centre.
Press OK to deliver water from the spout (A14)
until it flows out normally.
Replace the filter or remove it as described in
the section "Water filter".
Turn the froth adjustment dial to CLEAN.
Insert the water spout (D3) as far as it will go.
Insert the milk container (fig. 21) as far as it
will go.
SOLUTION
• Enable the cup warmer, leave the cups at
least 20 minutes to warm up.
• Warm the cups by rinsing them with hot
water (N.B. you can use the hot water
function).
Before making the coffee, warm the infuser by
using the Rinsing function to perform a rinse
cycle (page 10).
In the menu, set a higher coffee temperature.
Turn the grinding adjustment dial one click an-
ticlockwise towards "1" while the coffee mill is
in operation (fig. 12).
Continue one click at a time until coffee delive-
ry is satisfactory. The effect is only visible after
delivering 2 coffees (see the section: "adjusting
the coffee mill" on page 12).
Use pre-ground coffee for espresso coffee ma-
kers
Turn the grinding adjustment dial one click
clockwise towards "7" while the coffee mill is
in operation (fig. 12).
Continue one click at a time until coffee delive-
ry is satisfactory. The effect is only visible after
delivering two coffees. (see the section "adju-
sting the coffee mill" on page 12).
21