Hardware Installation; Front Panel; Rear Panel - TRENDnet TW100-S4W1CA User Manual

HARDWARE INSTALLATION

Front Panel

The figure below shows the front panel of the Broadband Router.
4-Port 10/100Mbps Ethernet Broadband Router Front Panel
POWER
This indicator lights green when the hub is receiving power. Otherwise, it
is off.
STATUS
This indicator blinks red when the Internet Broadband Router is
successfully working. If the indicator is either always on or off, the
Internet Broadband Router is not working properly.
WAN
This indicator lights green when the WAN port is connected to an
xDSL/Cable modem successfully.
This indicator blinks green while the WAN port is transmitting data to or
receiving data from the xDSL/Cable modem.
LAN (Link/ACT)
7
The port 1 - 4 indicators light green when they're connected to a 100Mbps
Fast Ethernet station. If the indicator blinks green, the corresponding LAN
port is transmitting or receiving data.

Rear Panel

The figure below shows the rear panel of the Broadband Router.
4 Port 10/100Mbps Ethernet Broadband Router Rear Panel
WAN
On the 4 port broadband router, there is an RJ-45 10/100Mbps Auto-
MDIX WAN port. This port connects to your xDSL/Cable modem.
LAN (1-4)
Four RJ-45 10/100Mbps Auto-MDIX ports for connecting to either
10Mbps or 100Mbps Ethernet connections.
RESET
Use a pin-shaped object to reset this device to factory default settings.
Resetting the device will also reset the login password to the default.
8