Connecting A Pc Or Mac; Remote Control Connection - Marantz SA-14S1 Owner's Manual

ENGLISH

Connecting a PC or Mac

By connecting a computer to the USB port on the rear panel of this unit using a commercially
available USB connecting cable, this unit can be used as a D/A converter "Using as a D/A
converter" (vpage 20).
Type A
Computer on which the
driver software and audio
player software are installed
• Install the dedicated driver software on the computer to enable communication between
the computer and this unit in order to playback high-resolution sound source (DSD signal or
192 kHz/24 bit PCM signal) audio available on the internet "Installing the dedicated driver
(Windows OS only)" (vpage 20).
• Download the driver software from the SA-14S1 page of the Marantz website.
NOTE
• Use a cable that is 3 m or less to connect to the computer.
11
Type B

Remote control connection

When you use this unit connected to a Marantz amplifier, this unit receives operation signals
sent from the amplifier and operates accordingly.
n Connection
Use the supplied remote connection cable to connect the REMOTE CONTROL IN connector
of this unit to REMOTE CONTROL OUT connector of the amplifier.
n Setting
Set the remote control switch on the rear panel of this unit to "EXTERNAL" to use this
feature.
• This setting will disable remote sensor reception of this unit.
• To operate the unit, point the remote control at the remote sensor of the amplifier.
To use this unit without connecting it to the amplifier, set the remote control switch to
"INTERNAL".
This unit
Remote connector cable
Signal flow
(supplied)
Set to "EXTERNAL".
Amplifier