Paper Changes Needed - Lexmark 210 User Manual

Troubleshooting
For non‑touch‑screen printer models, press
to clear the message and continue printing.
If you do not wish to accept these risks, then remove the third-party supply or part from your printer, and then install
a genuine Lexmark supply or part.
Note: For a list of supported supplies, see the "Ordering supplies" section of the User's Guide or visit
www.lexmark.com.
Not enough free space in flash memory for resources [52]
Try one or more of the following:
• From the printer control panel, select Continue to clear the message and continue printing. For non‑touch‑screen
printer models, press
• Delete fonts, macros, and other data stored in the flash memory.
•
Upgrade to a larger capacity flash memory card.
Note: Downloaded fonts and macros that are not previously stored in the flash memory are deleted.
PPDS font error [50]
Try one or more of the following:
•
From the printer control panel, select Continue to clear the message and continue printing. For non‑touch‑screen
printer models, press
•
If the printer cannot find the requested font, then from the printer control panel, navigate to:
PPDS menu > Best Fit > On
The printer will find a similar font and reformat the affected text.
• Cancel the current print job.

Paper changes needed

Try one or more of the following:
•
Select Use current supplies on the printer control panel to clear the message and continue printing.
For non-touch-screen printer models, press
•
Cancel the current print job.
Parallel port [x] disabled [56]
Try one or more of the following:
•
Select Continue to clear the message. For non-touch-screen printer models, press
The printer discards any data received through the parallel port.
•
Select Reset active bin to reset the bin for a linked set of bins.
and
to confirm.
to confirm.
to confirm.
on the printer control panel simultaneously for 15 seconds
297
to confirm.