Close Door Or Insert Cartridge; Disk Must Be Formatted For Use In This Device - Lexmark 210 User Manual

Troubleshooting
•
To clear the message and resume the job, select Continue on the printer control panel. For non-touch-screen printer
models, press to confirm.

Close door or insert cartridge

The toner cartridge is missing or not installed properly. Insert the cartridge, and then close all doors and covers.
Close rear door
Close the rear door of the printer.
Complex page, some data may not have printed [39]
Try one or more of the following:
•
From the printer control panel, select Continue to ignore the message and continue printing. For non‑touch‑screen
printer models, press
•
Cancel the current print job. For non‑touch‑screen printer models, press
•
Install additional printer memory.
Configuration change, some held jobs were not restored [57]
Held jobs are invalidated because of any of the following possible changes in the printer:
• The printer firmware has been updated.
•
The tray for the print job is removed.
•
The print job is sent from a flash drive that is no longer attached to the USB port.
•
The printer hard disk contains print jobs that were stored when the hard disk was installed in a different printer
model.
From the printer control panel, select Continue to clear the message. For non-touch-screen printer models, press
to confirm.
Defective flash detected [51]
Try one or more of the following:
•
Replace the defective flash memory card.
•
From the printer control panel, select Continue to ignore the message and continue printing. For non‑touch‑screen
printer models, press
•
Cancel the current print job.

Disk must be formatted for use in this device

From the printer control panel, select Format disk to format the printer hard disk and clear the message.
to confirm.
to confirm.
to confirm.
289