Table of Contents
Advertisement
Reverb Parameters
This is a reverb that is applied to the entire Live Set. You can choose from six types.
You can also adjust the amount of reverb that is applied to each layer by editing the REV (Reverb Send Level: owner's manual p. 28) from each of the
layers Upper 1--3 and Lower.
Settings common to all Reverb types
Parameter
Value
1: Room 1
2: Room 2
3: Hall 1
Type
4: Hall 2
5: Plate
6: GM2 Reverb
Level
0–127
1–5: Room 1/2, Hall 1/2, Plate
Parameter
Value
Pre Delay
0–100 [msec]
Time
0.1–10 [sec]
Density
0–127
Diffusion
0–127
LF Damp
0–100
HF Damp
0–100
Spread
0–127
Tone
0–127
6: GM2 Reverb
Parameter
Value
SMALL_ROOM,
MEDIUM_ROOM,
LARGE_ROOM,
Character
MEDIUM_HALL,
LARGE_HALL,
PLATE
Time
0–127
38
Explanation
Type of reverb
Room 1/2: Reverb that simulates
the reverberation of a room
Hall 1/2: Reverb that simulates the
reverberation of a hall
Plate: Simulation of a plate echo
(a reverb device that uses a metal
plate)
GM2 Reverb: GM2 reverb
Volume of the reverb sound
Explanation
Adjusts the delay time from the
direct sound until the reverb
sound is heard.
Time length of reverberation
Density of reverb
Adjusts the change in the density
of the reverb over time.
The higher the value, the more the
density increases with time.
(The effect of this setting is most
pronounced with long reverb
times.)
Adjusts the low-frequency portion
of the reverb.
Adjusts the high-frequency
portion of the reverb.
Reverb spread
Tonal character of the reverb
Explanation
Type of reverb
Time length of reverberation
Advertisement
Table of Contents
